|
|
Deuel, N. R., & Lawrence, L. M. (1987). Laterality in the gallop gait of horses. J Biomech, 20(6), 645–649.
Abstract: Bilateral asymmetry in gallop stride limb contact patterns of four Quarter Horse fillies was documented by high-speed cinematography. Horses were filmed with rider by two cameras simultaneously while galloping along a straightaway. Even though signaled for each gallop lead an equivalent number of times, horses frequently switched leads, selecting the left lead nearly twice as often as the right. Velocities and stride lengths were greater for the left lead than the right, but stride frequencies did not differ between leads. Velocity effects were partitioned out in limb contact data analysis to enable the determination of persistent gallop stride asymmetries. The contact duration for the trailing (right) fore limb on the left lead exceeded the contact duration for the trailing (left) fore limb on the right lead. Selecting the right fore limb as the trailing fore limb may have allowed horses to use it to withstand the greater stresses and caused them to preferentially gallop with the left fore limb leading. Laterality may have an important influence on equine gallop motion patterns and thereby influence athletic performance.
|
|
|
|
Hunt, G. R., & Gray, R. D. (2004). Direct observations of pandanus-tool manufacture and use by a New Caledonian crow (Corvus moneduloides). Anim. Cogn., 7(2), 114–120.
Abstract: New Caledonian crows are reported to have impressive pandanus-tool manufacture abilities. These claims are based on an extensive artefact record. However, inferring behavioural and cognitive abilities without direct observation of tool manufacture is problematic. Here we report (and document on video) direct observations of a crow making and using stepped pandanus tools at Pic Ningua. We observed (1) a bias for making tools on left edges consistent with that previously found at the site, (2) faithful manufacture of a stepped design with high overall congruence in the shapes of tools, (3) the use of convergent rips to first form the tapered end working away from the trunk then the wide end working towards the trunk, (4) appropriate functional use of stepped tools by use of the leaf-edge barbs to hook food from holes, and (5) consistent holding of tools on the left side of its head when using them. Our observations verify most of the claims based on the artefact record, but the crow's exact manufacture technique was slightly different to that inferred previously.
|
|
