Abstract: Twenty-four yearling Quarter Horse fillies were divided into three groups (I) very limited handling, (II) intermediate handling and (III) extensive handling. At about 14 months of age, each horse was preconditioned for 2 weeks and then run in a simple place-learning T-maze test in which it had to locate its feed. Thirty trials were run daily for 20 days, with the location of the feed changed each day. To retire from the maze, a horse had to meet the criterion: 11 correct responses in 12 tries, with the last eight being consecutive. Horses in Group II required the fewest trials to reach criterion. These horses also learned more and had the highest percentage of correct responses (P less than .05). Mean trainability tended to predict learning ability; however, trainability and trials to criterion were not significantly correlated. Mean emotionality scores indicated a tendency for horses in the intermediately handled group to be less emotional than those in Group I or III. Results indicated that horses with an intermediate amount of handling scored higher on an intermediate test of learning. All handled horses scored higher on learning tests than those not handled.

Abstract: The ability to jump over an obstacle depends upon the generation of work across the joints of the propelling limb(s). The total work generated by one hind limb of a horse and the contribution to the total work by four joints of the hind limb were determined for a jump. It was hypothesized that the hip and ankle joints would have extensor moments performing positive work, while the knee would have a flexor moment and perform negative work during the jump. Ground reaction forces and sagittal plane kinematics were simultaneously recorded during each jumping trial. Joint moment, power and work were determined for the metatarsophalangeal (MP), tarsal (ankle), tibiofemoral (knee) and coxofemoral (hip) joints. The hip, knee and ankle all flexed and then extended and the MP extended and then flexed during ground contact. Consistent with our hypothesis, large extensor moments were observed at the hip and ankle joints and large flexor moments at the knee and MP joints throughout ground contact of the hind limb. Peak moments tended to occur earlier in stance in the proximal joints but peak power generation of the hind limb joints occurred at similar times except for the MP joint, with the hip and ankle peaking first followed by the MP joint. During the first portion of ground contact (approximately 40%), the net result of the joint powers was the absorption of power. During the remainder of the contact period, the hind limb generated power. This pattern of power absorption followed by power generation paralleled the power profiles of the hip, ankle and MP joints. The total work performed by one hind limb was 0.71 J kg(-1). Surprisingly, the knee produced 85% of the work (0.60 J kg(-1)) done by the hind limb, and the positive work performed by the knee occurred during the first 40% of the take-off. There is little net work generated by the other three joints over the entire take-off. Velocity of the tuber coxae (a landmark on the pelvis of the animal) was negative (downward) during the first 40% of stance, which perhaps reflects the negative work performed to decrease the potential energy during the first 40% of contact. During the final 60% of contact, the hip, ankle and MP joints generate positive work, which is reflected in the increase of the animal's potential energy.

Abstract: Measurement of peak vertical ground reaction force (GRFz) from multiple limbs simultaneously during high-speed, over-ground locomotion would enhance our understanding of the locomotor mechanics of cursorial animals. Here, we evaluate the accuracy of predicting peak GRFz from duty factor (the proportion of the stride for which the limb is in contact with the ground). Foot-mounted uniaxial accelerometers, combined with UHF FM telemetry, are shown to be practical and accurate for the field measurement of stride timing variables, including duty factor. Direct comparison with the force plate produces a mean error of 2.3 ms and 3.5 ms for the timing of foot on and foot off, respectively, across all gaits. Predictions of peak GRFz from duty factor show mean errors (with positive values indicating an overestimate) of 0.8+/-0.04 N kg(-1) (13%; N=42; mean +/- S.E.M.) at walk, -0.3+/-0.06 N kg(-1) (3%; N=75) at trot, -2.3+/-0.27 N kg(-1) (16%; N=18) for the non-lead limb at canter and +2.1+/-0.7 N kg(-1) (19%; N=9) for the lead limb at canter. The substantial over- and underestimate seen at canter, in the lead and non-lead limbs, respectively, is attributed to the different functions performed by the two limbs in the asymmetrical gaits. The difference in load experienced by the lead and non-lead limbs decreased with increasing speed.

Abstract: REASONS FOR PERFORMING STUDY: In many equestrian activities a specific position of head and/or neck is required that is dissimilar to the natural position. There is controversy about the effects of these positions on locomotion pattern, but few quantitative data are available. OBJECTIVES: To quantify the effects of 5 different head and neck positions on thoracolumbar kinematics of the horse. METHODS: Kinematics of 7 high level dressage horses were measured walking and trotting on an instrumented treadmill with the head and neck in the following positions: HNP2 = neck raised, bridge of the nose in front of the vertical; HNP3 = as HNP2 with bridge of the nose behind the vertical; HNP4 = head and neck lowered, nose behind the vertical; HNP5 = head and neck in extreme high position; HNP6 = head and neck forward and downward. HNP1 was a speed-matched control (head and neck unrestrained). RESULTS: The head and neck positions affected only the flexion-extension motion. The positions in which the neck was extended (HNP2, 3, 5) increased extension in the anterior thoracic region, but increased flexion in the posterior thoracic and lumbar region. For HNP4 the pattern was the opposite. Positions 2, 3 and 5 reduced the flexion-extension range of motion (ROM) while HNP4 increased it. HNP5 was the only position that negatively affected intravertebral pattern symmetry and reduced hindlimb protraction. The stride length was significantly reduced at walk in positions 2, 3, 4 and 5. CONCLUSIONS: There is a significant influence of head/neck position on back kinematics. Elevated head and neck induce extension in the thoracic region and flexion in the lumbar region; besides reducing the sagittal range of motion. Lowered head and neck produces the opposite. A very high position of the head and neck seems to disturb normal kinematics. POTENTIAL RELEVANCE: This study provides quantitative data on the effect of head/neck positions on thoracolumbar motion and may help in discussions on the ethical acceptability of some training methods.