| Home | << 1 2 >> |
|
Dutto, D. J., Hoyt, D. F., Clayton, H. M., Cogger, E. A., & Wickler, S. J. (2004). Moments and power generated by the horse (Equus caballus) hind limb during jumping. J Exp Biol, 207(Pt 4), 667–674.
Abstract: The ability to jump over an obstacle depends upon the generation of work across the joints of the propelling limb(s). The total work generated by one hind limb of a horse and the contribution to the total work by four joints of the hind limb were determined for a jump. It was hypothesized that the hip and ankle joints would have extensor moments performing positive work, while the knee would have a flexor moment and perform negative work during the jump. Ground reaction forces and sagittal plane kinematics were simultaneously recorded during each jumping trial. Joint moment, power and work were determined for the metatarsophalangeal (MP), tarsal (ankle), tibiofemoral (knee) and coxofemoral (hip) joints. The hip, knee and ankle all flexed and then extended and the MP extended and then flexed during ground contact. Consistent with our hypothesis, large extensor moments were observed at the hip and ankle joints and large flexor moments at the knee and MP joints throughout ground contact of the hind limb. Peak moments tended to occur earlier in stance in the proximal joints but peak power generation of the hind limb joints occurred at similar times except for the MP joint, with the hip and ankle peaking first followed by the MP joint. During the first portion of ground contact (approximately 40%), the net result of the joint powers was the absorption of power. During the remainder of the contact period, the hind limb generated power. This pattern of power absorption followed by power generation paralleled the power profiles of the hip, ankle and MP joints. The total work performed by one hind limb was 0.71 J kg(-1). Surprisingly, the knee produced 85% of the work (0.60 J kg(-1)) done by the hind limb, and the positive work performed by the knee occurred during the first 40% of the take-off. There is little net work generated by the other three joints over the entire take-off. Velocity of the tuber coxae (a landmark on the pelvis of the animal) was negative (downward) during the first 40% of stance, which perhaps reflects the negative work performed to decrease the potential energy during the first 40% of contact. During the final 60% of contact, the hip, ankle and MP joints generate positive work, which is reflected in the increase of the animal's potential energy.
|
|
Belock, B., Kaiser, L. J., Lavagnino, M., & Clayton, H. M. (2012). Comparison of pressure distribution under a conventional saddle and a treeless saddle at sitting trot. The Veterinary Journal, 193(1), 87–91.
Abstract: It can be a challenge to find a conventional saddle that is a good fit for both horse and rider. An increasing number of riders are purchasing treeless saddles because they are thought to fit a wider range of equine back shapes, but there is only limited research to support this theory. The objective of this study was to compare the total force and pressure distribution patterns on the horse’s back with conventional and treeless saddles. The experimental hypotheses were that the conventional saddle would distribute the force over a larger area with lower mean and maximal pressures than the treeless saddle. Eight horses were ridden by a single rider at sitting trot with conventional and treeless saddles. An electronic pressure mat measured total force, area of saddle contact, maximal pressure and area with mean pressure >11 kPa for 10 strides with each saddle. Univariate ANOVA (P < 0.05) was used to detect differences between saddles. Compared with the treeless saddle, the conventional saddle distributed the rider’s bodyweight over a larger area, had lower mean and maximal pressures and fewer sensors recording mean pressure >11 kPa. These findings suggested that the saddle tree was effective in distributing the weight of the saddle and rider over a larger area and in avoiding localized areas of force concentration.
Keywords: Horse; Rider; Equitation; Tack; Electronic pressure mat
|
|
Clayton, H. M., Larson, B., Kaiser, L. A. J., & Lavagnino, M. (2011). Length and elasticity of side reins affect rein tension at trot. The Veterinary Journal, 188(3), 291–294.
Abstract: This study investigated the horse’s contribution to tension in the reins. The experimental hypotheses were that tension in side reins (1) increases biphasically in each trot stride, (2) changes inversely with rein length, and (3) changes with elasticity of the reins. Eight riding horses trotted in hand at consistent speed in a straight line wearing a bit and bridle and three types of side reins (inelastic, stiff elastic, compliant elastic) were evaluated in random order at long, neutral, and short lengths. Strain gauge transducers (240 Hz) measured minimal, maximal and mean rein tension, rate of loading and impulse. The effects of rein type and length were evaluated using ANOVA with Bonferroni post hoc tests. Rein tension oscillated in a regular pattern with a peak during each diagonal stance phase. Within each rein type, minimal, maximal and mean tensions were higher with shorter reins. At neutral or short lengths, minimal tension increased and maximal tension decreased with elasticity of the reins. Short, inelastic reins had the highest maximal tension and rate of loading. Since the tension variables respond differently to rein elasticity at different lengths, it is recommended that a set of variables representing different aspects of rein tension should be reported.
Keywords: Horse; Equitation; Training; Rein aids
|
|
Heleski, C. R., McGreevy, P. D., Kaiser, L. J., Lavagnino, M., Tans, E., Bello, N., et al. (2009). Effects on behaviour and rein tension on horses ridden with or without martingales and rein inserts. The Veterinary Journal, 181(1), 56–62.
Abstract: Unsteady hand position can cause discomfort to the horse, potentially leading to conflict behaviours (CB) such as head tossing or tail lashing. Some instructors feel that martingales or elastic rein inserts can reduce discomfort caused by inexperienced and unsteady hands. Others consider these devices to be inappropriate [`]crutches'. Four horses and nine riders were tested under three conditions in random order: plain reins, adjustable training martingales (TM), and elasticised rein inserts (RI). Rein-tension data (7Â s) and behavioural data (30Â s) were collected in each direction. Rein-tension data were collected via strain-gauge transducers. Behavioural data were assessed using an ethogram of defined behaviours. No differences in the number of CB were observed. Mean rein tension for TM was higher than that of RI or controls. Relative to the withers, the head was lower for horses ridden with martingales. Carefully fitted martingales may have a place in riding schools that teach novices.
Keywords: Horse behaviour; Horse welfare; Equitation science; Rein tension; Martingales
|
|
Geutjens, C. A., Clayton, H. M., & Kaiser, L. J. (2008). Forces and pressures beneath the saddle during mounting from the ground and from a raised mounting platform. The Veterinary Journal, 175(3), 332–337.
Abstract: The objective was to use an electronic pressure mat to measure and compare forces and pressures of the saddle on a horse's back when riders mounted from the ground and with the aid of a mounting platform. Ten riders mounted a horse three times each from the ground and from a 35 cm high mounting platform in random order. Total force (summation of forces over all 256 sensors) was measured and compared at specific points on the force-time curve. Total force was usually highest as the rider's right leg was swinging upwards and was correlated with rider mass. When normalized to rider mass, total force and peak pressure were significantly higher when mounting from the ground than from a raised platform (P < 0.05). The area of highest pressure was on the right side of the withers in 97% of mounting efforts, confirming the importance of the withers in stabilizing the saddle during mounting.
Keywords: Electronic saddle mat; Total force; Peak pressure; Equestrian; Kinetics
|
|
Clayton, H. M. (1993). The extended canter: a comparison of some kinematic variables in horses trained for dressage and for racing. Acta Anat (Basel), 146(2-3), 183–187.
Abstract: This study was designed to test the hypothesis that there is no significant difference in selected temporal and linear stride variables of the extended canter in horses bred and trained for dressage or racing. Nine advanced-level dressage horses and 7 Thoroughbred racehorses were filmed at a frame rate of 200 Hz at an extended canter on a sand track. Two strides were recorded per trial, and each horse performed 6 or 7 trials. Temporal and linear data were determined from the films, and descriptive statistics (mean, SD) were calculated. Strides were selected for analysis on the basis of having a velocity in the range of 6.0-7.0 m/s, and multivariate analysis of variance was used to detect significant differences in the stride kinematics of horses trained for the two sports (p < or = 0.01). The average velocity of the dressage horses was 6.37 m/s, compared with 6.40 m/s for the racehorses. There were no significant differences between the two groups in velocity, stride duration, stride length or the distances between limb placements. The stance durations of all four limbs and the overlaps between them were longer, whereas the duration of the suspension phase was shorter in the dressage horses than in the racehorses (p < or = 0.01). The time between impacts of the diagonal limb pair was close to zero in both groups, with individual horses showing some variability in the order of placement of the diagonal limb pair. However, the sequence of footfalls was not significantly different between the two groups (p < or = 0.01).
|
|
Argue, C. K., & Clayton, H. M. (1993). A preliminary study of transitions between the walk and trot in dressage horses. Acta Anat (Basel), 146(2-3), 179–182.
Abstract: The object of this study was to determine the limb support sequence during the transitions from walk to trot and from trot to walk in dressage horses under saddle and to test the null hypothesis that the limb support sequence during the transitions is not related to the level of training. Sixteen dressage horses training at novice to FEI Grand Prix level were videotaped performing an average of 9 transitions each from walk to trot and from trot to walk. The 30-Hz videotapes were viewed in slow motion, and based on the limb support sequence the transitions were categorized into two types. In type 1 transitions there were no intermediate steps between the walk and trot sequences. Type 2 transitions were characterized by intermediate steps, including a single support phase. The Kendall rank-order correlation coefficient showed that a higher level of training was positively associated with an increased percentage of type 1 transitions for both walk-to-trot transitions (p < or = 0.05) and trot-to-walk transitions (p < or = 0.01). No significant preference for initiating or completing the trot on the left or right diagonal was found using the binomial test for individual horses and the Wilcoxon signed-ranks test for the group.
|
|
Clayton, H. M. (1993). Development of conditioning programs for dressage horses based on time-motion analysis of competitions. J Appl Physiol, 74(5), 2325–2329.
Abstract: The time-motion characteristics of Canadian basic- and medium-level dressage competitions are described, and the results are applied in formulating sport-specific conditioning programs. One competition was analyzed at the six levels from basic 1 to medium 3. Each test was divided into a series of sequences based on the type and speed of activity. The durations of the sequences were measured from videotapes. The basic-level tests had fewer sequences, and they were shorter in distance and duration than the medium tests (P < 0.10), but the average speed did not differ between the two levels. It is recommended that horses competing at the basic levels be conditioned using 5-min exercise periods, with short (10-s) bursts of lengthened trot and canter included at basic 2 and above. In preparation for medium-level competitions, the duration of the work periods increases to 7 min, 10- to 12-s bursts of medium or extended trot and canter are included, and transitions are performed frequently to simulate the energy expenditure in overcoming inertia.
|
|
Hodson, E. F., Clayton, H. M., & Lanovaz, J. L. (1999). Temporal analysis of walk movements in the Grand Prix dressage test at the 1996 Olympic Games. Appl. Anim. Behav. Sci., 62(2-3), 89–97.
Abstract: Video analysis was used to measure temporal characteristics of the collected walk, extended walk and half pirouette at walk of eleven competitors during the team dressage competition at the 1996 Summer Olympic Games in Atlanta, GA. Forelimb stance durations, hind limb stance durations, lateral step intervals and diagonal step intervals were symmetrical for the right and left sides in the collected and extended walk strides, but there were left-right asymmetries in the forelimb stance duration and in the lateral step interval in the half pirouette strides. For both collected and extended walk strides, hind limb stance duration was significantly longer than forelimb stance duration. The mean values for the group of eleven horses showed that the collected and extended walks had a regular rhythm. The half pirouette strides showed an irregularity in which there was a short interval between footfalls of the outside forelimb and inside hind limb, and along interval between footfalls of the inside hind limb and inside forelimb. This irregularity reflected an early placement of the inside hind limb. The stance times of both hind limbs were prolonged and this finding, in combination with the early placement of the inside hind limb, led to an increase in the period of tripedal support in each stride of the half pirouette. This was interpreted as a means of maintaining the horses' balance in the absence of forward movement.
Keywords: Dressage; Horse; Kinematics; Locomotion; Gait
|
|
Clayton, H. M. (1995). Comparison of the stride kinematics of the collected, medium, and extended walks in horses. Am J Vet Res, 56(7), 849–852.
Abstract: Six horses, highly trained for dressage competition, were used to study the stride kinematics of the walk, and to compare the kinematics of the collected, medium, and extended walks. Horses were filmed in a sagittal plane at a rate of 150 frames/s; temporal, linear, and angular data were extracted from the films. Results of ANOVA and Duncan's multiple range test indicated that the speed of the collected walk (1.37 m/s) was significantly (P < 0.01) slower than that of the medium (1.73 m/s) and extended (1.82 m/s) walks, values for which were not significantly different from each other. The increase in speed was associated with a significant increase in stride length, from 157 cm in the collected walk to 193 cm in the extended walk. This was a result of an increase in the over-tracking distance, whereas there was no significant difference in the distance between lateral placements of the limbs. Stride duration decreased (P < 0.01) from the collected walk (1,159 ms) to the extended walk (1,064 ms). Angles of the metacarpal and metatarsal segments, measured on the palmar/ plantar aspect, were higher at impact and lower at lift off in the collected than in the extended walk (P < 0.01). This indicated greater range of angular motion of this segment during the stance phase in the extended walk. Only 1 of the 6 horses had a regular 4-beat rhythm of the footfalls, with equal time elapsing between the lateral and diagonal footfalls.
|