|
Hunt, G. R., Rutledge, R. B., & Gray, R. D. (2006). The right tool for the job: what strategies do wild New Caledonian crows use? Anim. Cogn., 9(4), 307–316.
Abstract: New Caledonian crows Corvus moneduloides (NC crows) display sophisticated tool manufacture in the wild, but the cognitive strategy underlying these skills is poorly understood. Here, we investigate what strategy two free-living NC crows used in response to a tool-length task. The crows manufactured tools to extract food from vertical holes of different depths. The first tools they made in visits were of a similar length regardless of the hole depth. The typical length was usually too short to extract food from the deep holes, which ruled out a strategy of immediate causal inference on the first attempt in a trial. When the first tool failed, the crows made second tools significantly longer than the unsuccessful first tools. There was no evidence that the crows made the lengths of first tools to directly match hole depth. We argue that NC crows may generally use a two-stage heuristic strategy to solve tool problems and that performance on the first attempt in a trial is not necessarily the 'gold standard' for assessing folk physics.
|
|
|
Hunt, G. R., & Gray, R. D. (2004). Direct observations of pandanus-tool manufacture and use by a New Caledonian crow (Corvus moneduloides). Anim. Cogn., 7(2), 114–120.
Abstract: New Caledonian crows are reported to have impressive pandanus-tool manufacture abilities. These claims are based on an extensive artefact record. However, inferring behavioural and cognitive abilities without direct observation of tool manufacture is problematic. Here we report (and document on video) direct observations of a crow making and using stepped pandanus tools at Pic Ningua. We observed (1) a bias for making tools on left edges consistent with that previously found at the site, (2) faithful manufacture of a stepped design with high overall congruence in the shapes of tools, (3) the use of convergent rips to first form the tapered end working away from the trunk then the wide end working towards the trunk, (4) appropriate functional use of stepped tools by use of the leaf-edge barbs to hook food from holes, and (5) consistent holding of tools on the left side of its head when using them. Our observations verify most of the claims based on the artefact record, but the crow's exact manufacture technique was slightly different to that inferred previously.
|
|
|
Hunt, G. R., & Gray, R. D. (2004). The crafting of hook tools by wild New Caledonian crows. Proc. Roy. Soc. Lond. B Biol. Sci., 271, S88–S90.
Abstract: The 'crafting' of tools involves (i) selection of appropriate raw material, (ii) preparatory trimming and (iii) fine, three-dimensional sculpting. Its evolution is technologically important because it allows the open-ended development of tools. New Caledonian crows manufacture an impressive range of stick and leaf tools. We previously reported that their toolkit included hooked implements made from leafy twigs, although their manufacture had never been closely observed. We describe the manufacture of 10 hooked-twig tools by an adult crow and its dependent juvenile. To make all 10 tools, the crows carried out a relatively invariant three-step sequence of complex manipulations that involved (i) the selection of raw material, (ii) trimming and (iii) a lengthy sculpting of the hook. Hooked-twig manufacture contrasts with the lack of sculpting in the making of wooden tools by other non-humans such as chimpanzees and woodpecker finches. This fine, three-stage crafting process removes another alleged difference between humans and other animals.
|
|
|
Hunt, G. R., Gray R.D., & Taylor, A. H. (2013). Why is tool use rare in animals? (Boesch C C. J. anz C, Ed.). Cambridge, MA.: Cambridge University Press.
|
|