Abstract: The aim of this study was to show that the motion pattern of a well-ridden horse varies less than the motion pattern of an unridden horse. In order to do so, we recorded the motion of two markers, one attached to the dorsal spinous processus of lumbar vertebra L4, the other to the right fore hoof. In total, we measured 21 horses in trot, ridden and unridden, with a fitting and with a non-fitting saddle. After breaking down the entire time series of the three-dimensional motion of the markers into their respective motion cycles, we computed a measure of motion pattern variability for the motion as well as for the derivatives (velocity and acceleration) along each of the three principal dimensions. Two of six variables (velocity and acceleration in the forward direction) displayed a significant discrimination between the ridden and the unridden case, and demonstrated the beneficial effect of a rider on the horse's motion pattern variability. Saddle fit was shown to have also an influence on motion variability: variability of two variables (velocity and of acceleration in forward direction) was significantly lower with a fitting saddle compared to a non-fitting saddle, a third variable (acceleration in the transversal direction) showed a significant difference also. This new method offers an objective evaluation of saddle fit, and a sensitive assessment of the quality of the rider in the moving horse.

Abstract: REASONS FOR PERFORMING STUDY: Fractures below the level of the radius or tibia (distal limb fractures) are the most common cause of equine fatality on UK racecourses; however, little is known about their epidemiology or aetiology. Identification of risk factors could enable intervention strategies to be designed to reduce the number of fatalities. OBJECTIVES: To identify horse-level risk factors for fatal distal limb fracture in Thoroughbreds on UK racecourses. METHODS: A case-control study design was used. Fractures in case horses were confirmed by post mortem examination and 3 matched uninjured controls were selected from the race in which the case horse was running. One hundred and nine cases were included and information was collected about previous racing history, horse characteristics and training schedules. Conditional logistic regression was used to identify the relationship between a number of independent variables and the likelihood of fracture. RESULTS: Horses doing no gallop work during training and those in their first year of racing were at significantly increased risk of fracture on the racecourse. Case horses were also more likely to have trained on a sand gallop, i.e. a gallop described by trainers as being primarily composed of sand. CONCLUSIONS: Modifications to training schedules, specifically within the first year of racing, may have a large impact on the risk of fatal distal limb fracture on the racecourse. Horses should do some gallop work in training and our results suggest that the minimum distance galloped should be between 805-2012 m (4-10 furlongs)/week. POTENTIAL RELEVANCE: The information from this study can be used to alter training schedules in an attempt to reduce the incidence of fatal distal limb fracture in Thoroughbred racehorses. Training should include some gallop work, and further studies, recording the exact level of work, will help to identify an optimum range of training speeds and distances which will reduce the liklihood of catastrophic fracture on the racecourse.

Abstract: Measurement of peak vertical ground reaction force (GRFz) from multiple limbs simultaneously during high-speed, over-ground locomotion would enhance our understanding of the locomotor mechanics of cursorial animals. Here, we evaluate the accuracy of predicting peak GRFz from duty factor (the proportion of the stride for which the limb is in contact with the ground). Foot-mounted uniaxial accelerometers, combined with UHF FM telemetry, are shown to be practical and accurate for the field measurement of stride timing variables, including duty factor. Direct comparison with the force plate produces a mean error of 2.3 ms and 3.5 ms for the timing of foot on and foot off, respectively, across all gaits. Predictions of peak GRFz from duty factor show mean errors (with positive values indicating an overestimate) of 0.8+/-0.04 N kg(-1) (13%; N=42; mean +/- S.E.M.) at walk, -0.3+/-0.06 N kg(-1) (3%; N=75) at trot, -2.3+/-0.27 N kg(-1) (16%; N=18) for the non-lead limb at canter and +2.1+/-0.7 N kg(-1) (19%; N=9) for the lead limb at canter. The substantial over- and underestimate seen at canter, in the lead and non-lead limbs, respectively, is attributed to the different functions performed by the two limbs in the asymmetrical gaits. The difference in load experienced by the lead and non-lead limbs decreased with increasing speed.

Abstract: The ability to jump over an obstacle depends upon the generation of work across the joints of the propelling limb(s). The total work generated by one hind limb of a horse and the contribution to the total work by four joints of the hind limb were determined for a jump. It was hypothesized that the hip and ankle joints would have extensor moments performing positive work, while the knee would have a flexor moment and perform negative work during the jump. Ground reaction forces and sagittal plane kinematics were simultaneously recorded during each jumping trial. Joint moment, power and work were determined for the metatarsophalangeal (MP), tarsal (ankle), tibiofemoral (knee) and coxofemoral (hip) joints. The hip, knee and ankle all flexed and then extended and the MP extended and then flexed during ground contact. Consistent with our hypothesis, large extensor moments were observed at the hip and ankle joints and large flexor moments at the knee and MP joints throughout ground contact of the hind limb. Peak moments tended to occur earlier in stance in the proximal joints but peak power generation of the hind limb joints occurred at similar times except for the MP joint, with the hip and ankle peaking first followed by the MP joint. During the first portion of ground contact (approximately 40%), the net result of the joint powers was the absorption of power. During the remainder of the contact period, the hind limb generated power. This pattern of power absorption followed by power generation paralleled the power profiles of the hip, ankle and MP joints. The total work performed by one hind limb was 0.71 J kg(-1). Surprisingly, the knee produced 85% of the work (0.60 J kg(-1)) done by the hind limb, and the positive work performed by the knee occurred during the first 40% of the take-off. There is little net work generated by the other three joints over the entire take-off. Velocity of the tuber coxae (a landmark on the pelvis of the animal) was negative (downward) during the first 40% of stance, which perhaps reflects the negative work performed to decrease the potential energy during the first 40% of contact. During the final 60% of contact, the hip, ankle and MP joints generate positive work, which is reflected in the increase of the animal's potential energy.

Abstract: Some Thoroughbred stallion farms separate the mare from the foal during breeding, leaving the foal alone in its stall. Such separation often leads to distress in the foal, as evidenced by behavioural indicators such as vocalisations, pacing or moving about, pawing and striking the body against solid objects. This study examined whether the foal's distress is reduced if a handler accompanies it during the period of separation. A total of 57 foals on an Irish stud farm were observed: 27 foals were accompanied during separation and 30 were left in isolation but discretely observed from outside the stall. On average, unaccompanied foals vocalised at significantly (P<0.001) shorter intervals (14.8 s versus 26.8 s), and spent significantly (P<0.05) more time pawing (29.6 s versus 6.8 s) than accompanied ones. In addition, 17 of the unaccompanied foals hurled themselves against a solid object on at least one occasion, while not one of the accompanied foals did this (P<0.001). Age, gender and number of times the foal had been previously separated from the mare while she was being teased or covered were not significantly related to any of the behavioural indicators of distress. Overall, the data provide clear evidence that accompanying a foal reduces the distress that it exhibits when separated from the mare. This procedure has obvious welfare benefits in the short term, in that the foal both experiences less distress and has a reduced likelihood of injuring itself, and it may have longer-term benefits by reducing the chance of the animal later developing a locomotory stereotypical behaviour.